RM新时代投资官网

As long as there is a fire-fighting system in the place, it must be necessary to do regular fire-fighting maintenance. Of course, as a part of the fire system, the fire smoke exhaust system must also be repaired.

每月檢查安裝螺栓有無銹蝕、松動，排煙系統基礎和支吊架應牢固，排煙系統驅動裝置外露部分。

Check whether the mounting bolts are rusted and loose every month, the foundation and supports and hangers of the smoke exhaust system shall be firm, and the exposed parts of the driving device of the smoke exhaust system shall be inspected.

防護罩、進出風口防護網或其他設施、防雨設施應完好有效。

The protective cover, air inlet and outlet protective net or other safety facilities and rainproof facilities shall be intact and effective.

檢查消防排煙系統維修應符合設計要求;傳動機構，應無變形、損傷，葉輪不應與外殼接觸。

Check that the maintenance of fire and smoke exhaust system shall meet the design requirements; The transmission mechanism shall be free from deformation and damage, and the impeller shall not contact with the shell.

每月檢查電動機接線應無松動，外殼應無腐蝕。

Check whether the motor wiring is loose and the shell is free of corrosion every month.

電源供電情況，電壓表、電源指示燈應正常。

Under the condition of power supply, the voltmeter and power indicator should be normal.

軸承部分潤滑油狀態及液位，應符合設計要求。

The lubricating oil status and liquid level of the bearing shall meet the design requirements.

檢查并維修消防排煙系統得傳動皮帶，應無松動，聯軸器應牢固。

Check and repair the drive belt of the fire and smoke exhaust system. It shall be free of looseness and the coupling shall be firm.

每月檢查電動機運轉及啟停狀態信號反饋功能，應正常。

Check the motor operation and start stop status signal feedback function every month, and it shall be normal.

每季度1次功能檢測試驗及供電線路檢查;每年對全部防煙、消防排煙系統維修進行1次聯動試驗和性能檢測，聯動功能性能參數應符合原設計要求。

Function test and power supply line inspection once a quarter; The linkage test and performance test shall be conducted once a year for the maintenance of all smoke control, fire control and smoke exhaust systems, and the linkage function performance parameters shall meet the original design requirements.

螺栓銹蝕部分，緊固松動的螺栓，加固排煙系統基礎和支吊架。

Remove the rusted part of the bolts, fasten the loose bolts, and strengthen the foundation, supports and hangers of the smoke exhaust system.

排煙系統房周?chē)扇嘉?緊固電動機接線端子，外殼除銹防腐。

Remove combustibles around the smoke exhaust system room; Fasten the motor wiring terminal and remove rust and corrosion on the housing.

軸承潤滑部位臟污、泥沙、塵土，補充潤滑油。

If the lubricating part of the bearing is dirty, silt and dust, supplement lubricating oil.

調整傳動皮帶松緊，加固聯軸器。

Adjust the tightness of the drive belt and reinforce the coupling.

以上就是水上川消小編今天帶給大家的精彩內容了，更多的精彩內容請點擊進入我們的網站http://www.guizhouhuli.net

The above is the wonderful content that shuichuan Xiaobian brought to you today. For more wonderful content, please click to enter our website http://www.guizhouhuli.net